MartinLogan Source Speakers Especificaciones descargar pdf (Pagina 13)

Troubleshooting 13

No Output

• Checkthatallyoursystemcomponentsareturnedon.

• CheckthatthemasterpowerswitchadjacenttotheAC

receptacleissetto'AutoOn'.

• Checkyourwiresandconnections.

• Checkallinterconnectingcables.

• Makesurethelevelcontrolisnotturneddown.

• TurnoffandunplugtheDynamo500andcheckthe

fuse near the AC power cord receptacle on the back. If

the fuse has blown, replace the bad fuse with a matching

T1.6AL250Vfuse(T0.8AL250Vifyouareina

regionusing230V).

• Iftheproblempersists,contactyourdealer.

Muddy Bass

• Checkplacement.Trymovingthesubwoofercloserto

the front and side walls.

• Decreasethelevel.

• Checkyourprocessorsetup.

• Iftheproblempersists,contactyourdealer.

Hums or Unusual Sounds

• TurntheDynamo500off,unplugallsignalinputs,turn

the Dynamo 500 back on and turn up the level. If the

problem disappears, the hum is originating elsewhere

in your system.

• ConnecttheDynamo500’sACconnectiontothesame

AC circuit as the pre amp.

• Iftheproblempersists,contactyourdealer.

Troubleshooting

trouBleshootIng

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

MartinLogan Source Speakers Especificaciones Pagina 13