MartinLogan FRESCO Especificaciones descargar pdf (Pagina 11)

Mounting the Fresco On A Wall or Ceiling 11

5 Set the wall bracket aside. Using a

" bit, drill a pilot hole

at all five points marked in the previous steps.

If a pilot hole hits a stud during this step, DO NOT WIDEN

that pilot hole or install a wall anchor at that location.

If a pilot hole does not hit a stud, use a

" bit to widen

that pilot hole and using a Phillips screwdriver install a wall

anchor so that it is flush with the wall (see figure 21).

6 Mount the wall bracket to the center wall anchor (or

pilot hole) using a 1" Phillips head screw driven through

the wall brackets center point. Do not fully tighten the

screw—the bracket must be leveled before installing the

remaining screws (see figure 22).

7 Using a level, square the bracket and drive the four

remaining 1" Phillips head screws into the wall anchors

(or pilot holes). Do not fully tighten the screws (see fig-

ure 22).

8 Using a level, make sure the bracket is level and tighten

all five screws (see figure 22).

Figure 21. Drill pilot holes and/or sink wall anchors at the 5 marked locations. Figure 22. Using a level, square the wall bracket and install the screws.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comentarios a estos manuales

Sin comentarios

MartinLogan FRESCO Especificaciones Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Altavoces MartinLogan FRESCO